Project 1.3 "Wall: Defining Boundaries", by Nachapol Kasemsuwan

Project 1.3 :Wall

Concept & Inspiration:  CONTINUOUS CONTOUR FORM

 Link To Full Resolution Final Model PDF

         This wall was design under the concept of “continuous contour form”. It’s composing of many horizontal S-curved panel made by “Aluminum Sheet”. Each panel are connect by tension force of “steel wire”, vertically. All the wires are attach and tied together to the ceiling and the floor. The load of the walls stabilizing the wire, which allow each panel extend and float on the air without any of it part touching the ground. With the difference in sizes it allow the gap between each panel gives different effect on indirect light and shadow.


 Prototype 1

prototype 2